displayvef.blogg.se - Water flow meter

#Water flow meter series#

The temperature resistance rating of 180☌ can meet the needs of measurement objects with fluid temperatures higher than 120☌. Among them, the temperature resistance rating of 120☌ can meet the measurement needs of most objects. The temperature grade can meet the needs.The measurement accuracy is high, and the high accuracy can still be achieved when the flow rate is very low.

#Water flow meter series#

From small to large caliber, the series is complete.

Because the inner diameter of the measuring pipe is the same as that of the pipe. Its significant advantages are as follows. Magnetic Water Flow Meter is a volumetric flow meter that measures liquids or liquid slurries that have a minimum conductivity of 5 µS/cm.Īn electromagnetic flowmeter is an ideal instrument for hot water flow measurement. Magnetic Water Flow Meter provide highly accurate flow measurements for a wide variety of conductive fluid applications. After the hot water valve is turned off, the market value of the flow should be 0.Įxtended Reading: Insertion Flowmeter Types In the heating season, the flow measurement range of up to 10 can meet the demand. A flow meter for heat measurement of a single user. The ratio of the maximum flow rate to the minimum flow rate is about 5~10. When the heat supply is the smallest, generally only a small pump is turned on. When the hot water supply is at its maximum, usually several large pumps are opened. The pumps used in power plants (stations) to deliver hot water are generally combined in size.

The requirement for scope is not high.

Ordinary stainless steel materials are corroded, and the higher the fluid temperature, the more severe the corrosion.

Because it contains chloride ions and so on. However, geothermal water has a certain degree of corrosion. Fresh water does not corrode the flowmeter. The solid matter in the single water and its viscosity will not have a big impact on the general flowmeter. The large-diameter flowmeter sometimes reaches about 1m. The smallest user, the pipe diameter is only DN20~DN40.

In the ground heating system, the highest pressure is 1MPa. In order to send hot water to the highest floor in the building heating system, the pressure is sometimes higher. The measured fluid pressure is not very good either.When the liquid outlet of the heat exchanger is installed, the flow temperature is lower. The temperature of the fluid is generally not higher than 140☌. When the flow meter is installed at the entrance of the heat exchanger body. The temperature of the measured fluid is not very high.What are the characteristics of hot water flow measurement? Let’s take a look.